Testimonials

Bluegrass Army Depot
Bluegrass Army Depot received a project where cycle time was a HUGE issue. They hired another source to setup tooling and write the program for the turning center. Cycle time was just over 2 minutes and they needed to get it down to 1.5 minutes. On my last day of training I proceeded to review the program, tooling, and process for this part. I set up an additional tool, altered the process and edited the program with the intent of reducing cycle time. On our 1st part we achieved 1 min. 30 sec. cycle time on the money. Customer satisfaction!!

Eastern Manufacturing
1st Part Process: Eastern Manufacturing wanted to gain the ability of producing parts in house without the initial expertise of process engineering, programming, and operating a fully automated CNC Lathe. Read about full 1st Part Process solution here >

Students
"I really enjoyed the course, it was very well explained and I feel so much more comfortable trying to run a CNC. In fact I welcome the challenge of learning more and operating a CNC. I wish the course was longer so I could learn more!"

"Course is in-depth and flexible enough to meet the needs of the trainees."

"Excellent structure to the course, but it remained flexible enough to delve into questions and get through the answers, then get right back on track."

US Army
Thank you, for the training on the new machines. FYI--Bob Bohinski is running the machine today and producing more chips than he's ever produced on a vertical. And he
isn't running anywhere near the machines capacity. He loves it!

Moody Air Force Base

"Lots of hands-on training."

"Instructor was very knowledgeable."

"The hand outs and training materials were applicable to our job."

Knolls Atomic Power, Schenectady, New York

"Great one-on-one instruction."

"Excellent handouts, especially the thread depth formula and the G & M code charts."

Eglin Air Force Base

"The course was presented and laid out very well. Every area was covered well."

"I really enjoyed the Quick Code portion."

FRCSE, Jacksonville, Florida

"I felt that the instructor was well prepared and very knowledgeable, he answered all of my questions and concerns in great detail."

"We spent enough time on the key-pad and at the screen to feel comfortable with the machine."

"Before the training I had no confidence in running the machine. Due to the training I have gained confidence that I can run and program this machine."

U.S. Mint, Philadelphia

"After this training I am able to use this lathe with confidence."

"The training materials were written in easy to use terms."

"The most useful part of the training was the hands-on time."

Naval Air Warfare Center, Lakehurst, New Jersey

"Visual Quick Code and IPS will come in handy."

"The training made a machinist that wasn't used to G & M code programming feel very comfortable in front of the machine."

"The instructor knew the machine inside and out."